Muc-Off Fork Protection Kit - PUNK - New

STEP 1. Clean your bike thoroughly before application. For best results and optimum durability spray Muc-Off Disc Brake Cleaner or Dry Degreaser onto a clean, dry microfibre cloth and wipe over the surface to ensure it is contaminant free. (Always test the disc brake/dry degreaser cleaner on a small inconspicuous area prior to use to ensure finish compatibility!) STEP 2. Try to fit the guards in a clean and warm environment, this will help achieve good adhesion to the surface. TOP TIP! If you are applying in colder conditions and have access to a hairdryer then carefully warm the surface. This will help achieve anoptimal adhesive bond. STEP 3. Peel the guards off the backing material and line up the centre of the guards to the area you are applying. NB: It's important you start with each sticker in the dead center of the area you are applying so chill, do some yoga or hitup some CBD beforehand* and take your time on this section! :) Then slowly rub down the middle, working your way out to the sides pushing out any air bubbles to the edges. TOP TIP! You can easily trim the shapes as required if necessary, with clean, sharp scissors if you need to fit around any challenging shapes or frame mounts etc. STEP 4. Use a clean microfibre cloth to firmly rubdown the guards onto the surface and make sure you cover all areas with even pressure. STEP 5. Sit back and admire your freshly wrapped pride and joy, now go ride without the stress of scratching your pony! REMOVAL: Ready to switch up your graphics? Removal is easy! STEP 1. Start by gently heating the surface of the stickers with a hairdryer. This will help soften the adhesive, then slowly start peeling up a corner of the guards and peel back as carefully as you can, try to keep the adhesive attached to the protective layer so it all comes off in one piece. STEP 2. Once each protection guard is removed use Muc-Off Glue & Sealant Remover to easily remove any residue before re-installing your new guards! (Always test the Glue & Sealant Remover on a small inconspicuous area prior to use to ensure finish compatibility!).